Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in the medium-density fiberboard (MDF material) by using our brand woodwork auger bit?
A: Yes, medium-density fiberboard (MDF material) looks like a board, has similar fibrous material. Thus, When you make it a hole, it may stick fibers at the screw point. However, after removing fibers, it will be back to normal.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in the siding board with our brand hex shank drill cutter? A: Yes. But,…
    FAQ

  • 2021.05.18

    No.20 Hex Shank…

    Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex…
    FAQ

  • 2021.05.18

    No.100 Kotenoko…

    Q: Does Kotenoko 135 give damage to the cutting surface? A: No, it does not give any damage to the…
    FAQ

  • 2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in stainless steel by using our brand hex shank drill cutter? A: No, it…
    FAQ

  • 2021.05.18

    No.51 Hex Shank…

    Q: Can I make a hole in the metal-based siding board by hex shank siding drill bits (carbide tool)? A:…
    FAQ