Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in the medium-density fiberboard (MDF material) by using our brand woodwork auger bit?
A: Yes, medium-density fiberboard (MDF material) looks like a board, has similar fibrous material. Thus, When you make it a hole, it may stick fibers at the screw point. However, after removing fibers, it will be back to normal.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.100 Kotenoko…

    Q: Does Kotenoko 135 give damage to the cutting surface? A: No, it does not give any damage to the…
    FAQ

  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    No.20 Hex Shank…

    Q: Is there one point tip to advise for making a big hole by using the iron drill bits, stainless…
    FAQ

  • 2021.05.18

    No.21 HSS Taper…

    Q: How big size of pre-hole by our brand HSS Tapered Auger Bits? A: the size of the pre-hole for…
    FAQ

  • 2021.05.18

    No.22 Hex Shank…

    Q: Why does the hole size of making by our hex shank dowel bits make small to compare of actual…
    FAQ