Tips

FAQ

No.28 Hex Shank Taps / No.28-T Composite shank taps / No.28-S Hex Shank Spiral Taps / No.28-P Hex Shank Stainless Steel Point Taps / No.50 Hex Shank Tapping Drill / No.29 Hex Shank Dies Holder

Q: Please teach me to avoid breaking the Hex Shank tap risk.
A: One point of advice is to keep using cutting oil and to keep checking the speed rotating of the driver. And, Please use vertical processing to a prepared hole.
By doing so, the breaking risk will be less happen and to keep long period using.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.21 HSS Taper…

    Q: How big size of pre-hole by our brand HSS Tapered Auger Bits? A: the size of the pre-hole for…
    FAQ

  • 2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in the siding board with our brand hex shank drill cutter? A: Yes. But,…
    FAQ

  • 2021.05.18

    No.20 Hex Shank…

    Q: Please kindly teach me one point tip to keep using the long period of Iron drill and our brand…
    FAQ

  • 2021.05.18

    Pliers

    Precautions for using our brand pliers. Please make sure the wire size, crimp terminal size and tool size, etc. If…
    Attention

  • 2021.05.18

    No.22 Hex Shank…

    Q: Why does the hole size of making by our hex shank dowel bits make small to compare of actual…
    FAQ