Tips

Attention

No.1-S Stopper Auger Bits (short)

Precautions for use drill bits on the drill press
Please be careful to use our Stopper Auger Bits on the drill press since the Stopper Auger Bits has a thread at one side, this thread may lift up at work material. Moreover, by filing at the thread on the head little, you take off burr, it won’t be lifting up work material and not reduced work efficiency.

Back to the List

OTHEROther【AttentionFAQ】articles

  •

    2021.05.18

    Our brand woodw…

    Q: Can I make a hole in rubber by using our brand woodworking auger bits? A: No, it is not…
    FAQ

  • 2021.05.18

    No.30 Hex Shank…

    Q: Can I make a hole in shells and corals by using porcelain tile drill bits? A: Yes, it is…
    FAQ

  • 2021.05.18

    No.27 SDS Shank…

    Q: Can I make a hole in stainless steel by using SDS Shank Iron Drill Bits? A: Yes, it is…
    FAQ

  • 2021.05.18

    No.51 Hex Shank…

    Q: Can I make a hole in the metal-based siding board by hex shank siding drill bits (carbide tool)? A:…
    FAQ

  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention