Tips

FAQ

No.28 Hex Shank Taps / No.28-T Composite shank taps / No.28-S Hex Shank Spiral Taps / No.28-P Hex Shank Stainless Steel Point Taps / No.50 Hex Shank Tapping Drill / No.29 Hex Shank Dies Holder

Q: Please teach me to avoid breaking the Hex Shank tap risk.
A: One point of advice is to keep using cutting oil and to keep checking the speed rotating of the driver. And, Please use vertical processing to a prepared hole.
By doing so, the breaking risk will be less happen and to keep long period using.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.51 Hex Shank…

    Q: Can I make a hole in the metal-based siding board by hex shank siding drill bits (carbide tool)? A:…
    FAQ

  • 2021.05.18

    No.100 Kotenoko…

    Q: Does Kotenoko 135 give damage to the cutting surface? A: No, it does not give any damage to the…
    FAQ

  • 2021.05.18

    No.1-S Stopper …

    Precautions for use drill bits on the drill press Please be careful to use our Stopper Auger Bits on the…
    Attention

  • 2021.05.18

    No.28 Hex Shank…

    Q: Can I make screw threads on aluminum material? A: Yes. But aluminum material is quality of being tenacious, so…
    FAQ

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in the medium-density fiberboard (MDF material) by using our brand woodwork auger bit? A:…
    FAQ