Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in rubber by using our brand woodworking auger bits?
A: No, it is not recommended, it has a screw at the head point.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.28 Hex Shank…

    Q: What are the differences in the type of Hex Shank Taps of our products between No.28, No.28S, and No.28P?…
    FAQ

  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    No.20 Hex Shank…

    Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex…
    FAQ

  • 2021.05.18

    Pliers

    Precautions for using our brand pliers. Please make sure the wire size, crimp terminal size and tool size, etc. If…
    Attention

  • 2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in stainless steel by using our brand hex shank drill cutter? A: No, it…
    FAQ