Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in plastic and polyvinyl chloride pipe (PVC) by using our brand woodworking auger bits?
A: No, it is not recommended, it has a screw at the head point.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.36 Mushroom …

    Q: If I want to make a further depth hole by using Mushroom Hammer, how I can make it? A:…
    FAQ

  • 2021.05.18

    No.27 SDS Shank…

    Q: Can I make a hole in stainless steel by using SDS Shank Iron Drill Bits? A: Yes, it is…
    FAQ

  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    No.20 Hex Shank…

    Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex…
    FAQ

  • 2021.05.18

    No.28 Hex Shank…

    Q: How can I calculate recommended pre-hole size? A: The format of recommended pre-hole is that size - thread pitch…
    FAQ