Tips

FAQ

No.20 Hex Shank Iron Drill Bits / No.20-L Hex Shank Long Iron Drill Bits

Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex Shank Long Iron Drill bits?
A: Yes, it is possible. But it can not make a clean circle hole, because the material of the Fiber Reinforced Plastics (FRP) will leave burr a lot.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.51 Hex Shank…

    Q: Can I make a hole in autoclaved lightweight concrete panels (ALC) by hex shank siding drill bits (Carbide tool)?…
    FAQ

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in the medium-density fiberboard (MDF material) by using our brand woodwork auger bit? A:…
    FAQ

  • 2021.05.18

    No.28 Hex Shank…

    Q: What does the best cutting oil types for Hex Shank taps? A:There are many types of cutting oils. The…
    FAQ

  • 2021.05.18

    No.28 Hex Shank…

    Q: What are the differences in the type of Hex Shank Taps of our products between No.28, No.28S, and No.28P?…
    FAQ

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in rubber by using our brand woodworking auger bits? A: No, it is not…
    FAQ