Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in bamboo by using our brand woodworking auger bits?
A: Yes. But, it is not recommended to use with screw point type bit, because it may happen to break the bamboo fiber.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in stainless steel by using our brand hex shank drill cutter? A: No, it…
    FAQ

  • 2021.05.18

    No.30 Hex Shank…

    Q: Can I make a hole in shells and corals by using porcelain tile drill bits? A: Yes, it is…
    FAQ

  • 2021.05.18

    No.25 SDS Shank…

    Q: Can SDS shank wood auger bits use for SDS max? A: No. Our brand SDS shank auger bits only…
    FAQ

  • 2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    No.20 Hex Shank…

    Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex…
    FAQ