Tips

FAQ

No.28 Hex Shank Taps / No.28-T Composite shank taps / No.28-S Hex Shank Spiral Taps / No.28-P Hex Shank Stainless Steel Point Taps / No.50 Hex Shank Tapping Drill / No.29 Hex Shank Dies Holder

Q: Can I make screw threads on aluminum material?
A: Yes. But aluminum material is quality of being tenacious, so please use cutting oil much.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in bamboo by using our brand woodworking auger bits? A: Yes. But, it is…
    FAQ

  • 2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in the siding board with our brand hex shank drill cutter? A: Yes. But,…
    FAQ

  • 2021.05.18

    No.21 HSS Taper…

    Q: How big size of pre-hole by our brand HSS Tapered Auger Bits? A: the size of the pre-hole for…
    FAQ

  • 2021.05.18

    No.20 Hex Shank…

    Q: Is there one point tip to advise for making a big hole by using the iron drill bits, stainless…
    FAQ