Tips

FAQ

No.22 Hex Shank Dowel Bits

Q: Why does the hole size of making by our hex shank dowel bits make small to compare of actual size diameter?
A: Sometimes, it may be the elasticity of dryness wood dowel, when you use a wood dowel. While considering that point, the stopper will thin of actual size dimeter. When round bar use, please fit it into cross-section.

OTHEROther【FAQ】articles

  • 2021.05.18

    No.27 SDS Shank…

    Q: Can I make a hole in stainless steel by using SDS Shank Iron Drill Bits? A: Yes, it is…
    FAQ
  • 2021.05.18

    No.20 Hex Shank…

    Q: Is there one point tip to advise for making a big hole by using the iron drill bits, stainless…
    FAQ
  • 2021.05.18

    No.1-S Stopper …

    Precautions for use drill bits on the drill press Please be careful to use our Stopper Auger Bits on the…
    Attention
  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in the medium-density fiberboard (MDF material) by using our brand woodwork auger bit? A:…
    FAQ
  • 2021.05.18

    No.100 Kotenoko…

    Q: Does Kotenoko 135 give damage to the cutting surface? A: No, it does not give any damage to the…
    FAQ