Tips

FAQ

No.28 Hex Shank Taps / No.28-T Composite shank taps / No.28-S Hex Shank Spiral Taps / No.28-P Hex Shank Stainless Steel Point Taps / No.50 Hex Shank Tapping Drill / No.29 Hex Shank Dies Holder

Q: Can I make screw threads on aluminum material?
A: Yes. But aluminum material is quality of being tenacious, so please use cutting oil much.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.29 Hex Shank…

    Precautions for use our brand Hex Shank Dies Holder. There is different overseas inch size standard of round dies. Therefore,…
    Attention

  • 2021.05.18

    No.20 Hex Shank…

    Q: Is there one point tip to advise for making a big hole by using the iron drill bits, stainless…
    FAQ

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in rubber by using our brand woodworking auger bits? A: No, it is not…
    FAQ

  • 2021.05.18

    No.28 Hex Shank…

    Q: How can I calculate recommended pre-hole size? A: The format of recommended pre-hole is that size - thread pitch…
    FAQ

  • 2021.05.18

    No.51 Hex Shank…

    Q: Can I make a hole in autoclaved lightweight concrete panels (ALC) by hex shank siding drill bits (Carbide tool)?…
    FAQ