Tips

FAQ

Our brand woodworking auger bits (general)

Q: Can I make a hole in bamboo by using our brand woodworking auger bits?
A: Yes. But, it is not recommended to use with screw point type bit, because it may happen to break the bamboo fiber.

Back to the List

OTHEROther【FAQ】articles

  •

    2021.05.18

    No.23 Hex Shank…

    Q: Can I make a hole in the siding board with our brand hex shank drill cutter? A: Yes. But,…
    FAQ

  • 2021.05.18

    Our brand woodw…

    Q: Can I make a hole in plastic and polyvinyl chloride pipe (PVC) by using our brand woodworking auger bits?…
    FAQ

  • 2021.05.18

    No.28 Hex Shank…

    Q: Please teach me to avoid breaking the Hex Shank tap risk. A: One point of advice is to keep…
    FAQ

  • 2021.05.18

    No.100 Kotenoko…

    Q: Does Kotenoko 135 give damage to the cutting surface? A: No, it does not give any damage to the…
    FAQ

  • 2021.05.18

    No.20 Hex Shank…

    Q: Can I make a hole in the fiber-reinforced plastics (FRP) by using Hex Shank Iron Drill Bits and Hex…
    FAQ